#73 - VSPB cell chamber construction

Back


Construction details for the PVC chamber for the new vertical HHO electrolyzer cell.

Categories: HOH, Efficient Home heating, Energy Conservation, Renewable Energy, Alternate Energy, Hydrogen Fuel Cell, Hybrid Electric Car, Solar power, Wind Power, Gas Mileage Booster, Science Fair, Greenhouse Gases, CO2, Water Fuel Cell.

Channel: Science & Technology
Uploaded: April 15, 2008 at 10:47 pm
Author: ZeroFossilFuel

Length: 00:08:37
Rating: 4.78
Views: 24143

Tags: HHO Hydrogen fuel cell hybrid electric car solar power alternate energy water4gas magdrive mileage booster science fair

Video Comments:
flipster12000 (September 18, 2008 at 10:49 am)
You can use a clean out collar on the bottom of the cell also just screw in the clean out cap in UPSIDE DOWN. It will make a nice sturdy and flat bottom for your containers, or use a rubber pressure cap with a stainless hose clamp.
wwwrowndoat (August 3, 2008 at 3:24 am)
One question
between every 2 contacts to supply power, there are 5 steel plates. What is their potential, I mean, what are they connected to? do you use neutral plates?
ZeroFossilFuel (August 3, 2008 at 7:31 am)
You're new here. Aren't you?

Please go to my web site and read my FAQ.
FluorideIsBadForYou (July 24, 2008 at 10:09 pm)
This guy uses stainless steel pipes

youtube . com/user/daddyo44907
goldf100 (July 21, 2008 at 2:05 am)
Is the piping heat proof ?

At what temp will the water be?
rhblakeman (June 16, 2008 at 8:47 am)
There are two SCH40 types, one is solid and one is foam core. Get the heavier and harder solid, not the foam core. Foam core is great for drains, terrible for containment of a hot cell. ABS foam core does work though but it's good to like 180 degrees where PVC is 150 or 130 for foam core.

Zero - Lowes sells 24" lengths also. Good way to cut is mark first. Find something that cradles or V's the pipe and has a fixed stop then hold a pencil in place and turn while making a mark. Should be square
rhblakeman (June 16, 2008 at 8:55 am)
A long cable (zip) tie snugged up around the pipe at one mark will almost go perfect for a mark too and you can check the measurment and adjust then use the tie like you did as pencil or marker guide. Take the tie off and cut. You can get unlockable long ties as well and reuse them. When I do PVC for sewer I have a wood V I use and put my 7" saw at the mark and once into the pipe I simply spin. Rare to get an odd cut.
will4ward (December 10, 2008 at 11:48 am)
Maybe I'm out of school, but I always cut the pipe in a chop/miter saw .
Go easy and masking tape the cut area to prevent
chipping,wear eye protection.
Perfect cuts.
magicuncovered (June 9, 2008 at 11:57 pm)
Home depot has a pipe cutting machine, they do it free and gives a perfect straight line cut, or use a 6" ABS pipe cutter wheel.
ZeroFossilFuel (June 10, 2008 at 3:17 am)
I knew they cut wood panels for free. Didn't know about the pipe. Thanks for the tip!